UNITROL WELD CONTROLS
The SOLUTIONi is a full featured highly accurate resistance welding control that is very easy to use. In fact you can set up and use this control without looking at a direction book!
It is that intuitive.
Here’s how it works:
It asks questions and you answer by pushing the YES
or NO button.
It asks you to enter numbers and then tells you what to
You tell it the type of metal you are welding and the thinnest sheet being joined. It will set up an RWMA welding schedule ready to use.
It has a MASTER SETUP button. When pushed it walks you through all user-settings with clear English instructions. This is very useful when first installing a control.
It tells you the required air pressure regulator setting for the part you are welding.
It tells you the recommended welder transformer tap switch position for each part.*
It waits until the proper ELECTRODE FORCE has been reached before starting each weld and eliminates the need for SQUEEZE TIME.*
It checks ELECTRODE FORCE again at the end of the weld to be sure that you have not made a brittle weld by having ELECTRODE FORCE that is too high.*
It keeps the electrodes closed when any weld fault is detected and tells you how to reset it.
It tells you when to dress electrodes.
And it does all of the above in clear English,
without any codes.